2000年12月6日 · Moderator: Gary Katz A production approach to high-quality finish work.

2005年10月24日 · (Two 12-2 romex in a 22.5 CI box.) Unroll and sort the wires, cut to length, strip the wires, form the hooks, screw the hooks down to the terminals, fold the wires back into the box, screw in the receptacle, check and adjust for flush appearance if necessary, and then screw on the cover plate and move on to the next one.

2002年12月23日 · Carbide tip drill bit will do the job on wall tile. I use a regular plastic anchor and screw, and I'll put a dab of caulk in the anchor hole before I put the screw in. This will help seal the hole for additional moisture protection. After the bar is mounted, I'll use some white phenoseal around the edge, like grout, to seal it up. Good luck.

2008年3月1日 · A couple carefully placed finish nails can help hold up long runs of crown. You can also look into crown hooks. You screw through a keyhole above the line of the crown on the wall and rest the crown in the hook. then simply slide the hook off the screw and remove it. I also have the Bosch laser measurer. Mine is accurate enough to measure trim.

2007年1月8日 · Try hanging them from the ceiling. You can paint all 6 sides at the same time & only have 2 screw holes to fill in (in the top) where the hooks go in. Shortens the time significantly & prevents painters brain fart... aka "PBF syndrome" Painters Brain Fart: the process in which a painter forgets to paint the top & bottom of a door.

2001年7月31日 · After the rain slowed, I got a ladder and here's what I found: The gutters were installed over the drip edge with hiden hangers (the type that hook under the front lip and over the back edge of the gutter, then a screw goes thru the back of the gutter into the facia).

2009年3月26日 · We use a couple of Dewalt orbital sanders with a hook-and-loop pad, which needs to be replaced once in a while. My workers picked up a replacement pad at a swap meet that appears to have more aggressive hooks on it. Don't know if it will last longer or not. Some types of phillips bits will jam in the nose of the Dewalt impact gun.

2008年3月12日 · OR you can toggle right thru the stud---- very strong but time consuming. If it is 20 ga or heavier, use a fine thread screw and hit the studs, maybe three screws in each stud. You might want to use a self drilling screw. I always tend to over do it. I dont want a call back about a cabinet falling of a wall and hurting someone. bradcas

2015年7月19日 · Re: rubbing drawer fronts The metal prongs at the rear of the slide Blum calls hooks. If you look just behind and on top of the hook you should see a small grey lever on a wheel. Moving that lever left and right will adjust the drawer rear up and down. Bob

2010年6月1日 · Re: Attaching &quot;shed&quot; to stucco? A detached shed doesn't require plans or permits as long as it is < 64 sq feet and eight feet tall with no utilities.