2019年7月1日 · Apply a continuous cementitious tanking slurry to the outside of the single skin brick wall, all the way down to the foundations. This would cover the current DPC layer and even the two courses of bricks between the DPC and the foundations.

2017年1月24日 · For a garage, KA tanking slurry, then treated battens screwed to wall with silicone squeezed into the holes before plug and screw goes in, then insulation, then foilback plasterboard. P pde100

2024年3月23日 · Then building regs suggest you need to apply a tanking compound under the tiles so I coated the plasterboard in KA Tanking slurry. Now I’ve come back to apply the second coat a week later and I can rub the first coat off with my hand if I rub hard.

2021年2月17日 · So I did a bit of research online.... Found that TANKING was the solution. So we bought 2 buckets of KA Tanking Slurry. Applied the first coat (White) then within 24 hours the 2nd Coat (grey) and a 3rd coat to make sure. This was 3 weeks ago now.... We are still seeing water coming through.

2021年7月28日 · Hello, a couple of years ago I used a product called KA tanking slurry to seal a wet wall, Wall is single brick internal dividing wall. An insulated slab is in place on each side of the wall. After drying, the surface showed dark lines corresponding with the mortar between the brick courses. Also a couple of places where the damp bled through.

2024年8月5日 · Tanking the wall and then applying moisture-resistant board is a viable approach to address rising and penetrating damp, especially if removing the existing plaster is impractical. Tanking will create a waterproof barrier that helps prevent moisture from reaching the interior, while the moisture-resistant board provides an additional layer of ...

2019年3月10日 · if there is polystyrene backing is rather advisable to fix it with some screws in addition to dot and dab, this can be gained (without damage/weakening to your slurry by installing couple of treated buttons on the wall using gripfill or other no …

2016年11月22日 · Hi All We're applying KA tanking slurry to a concrete garage floor 80sqm. The garage is for cars, but it also includes two additional rooms. Importantly it's below the water table and the driveway slopes towards it. There are adequate drains in place but as a belt-&-braces approach it's been...

2020年6月1日 · Going to use an SBR slurry mix on back of the slabs before laying, to aid adhesion to slabs etc, what is the best mix, some require no water others suggest 1:1:5 (sbr/water/cement). Does this sound about right? I have about 50 x 600mm x 600mm to lay and hoping that 5 litres will be enough (its expensive stuff). Thanks in advance

2009年6月4日 · For most of the tanking I do (1000mm up from damp) when doing wet rooms etc I use an additive called sika 1, apparently this product is used in water towers etc has to be mixed in a bucket though not in a mixer!!!!!