2007年5月28日 · Vlan Std range is from 1-1001 (1002-1005 are reserved) Extended range is the same but differs on CATOS switches. Yes, your switch has to be in VTP transparent mode to configure the extended range vlans.

2012年4月26日 · "VTP version 1 and version 2 support only normal-range VLANs (VLAN IDs 1 to 1005). In these versions, the switch must be in VTP transparent mode when you create VLAN IDs from 1006 to 4094. VTP version 3 supports the entire VLAN range (VLANs 1 to 4094). Extended range VLANs (VLANs 1006 to 4094) are supported only in VTP version 3.

2016年10月10日 · interface range g1/0/1 - 18. switchport access vlan 10. 21 Helpful Reply. Go to solution. Joseph W. Doherty.

2019年4月15日 · Could someone please explain me as to how to find the IP address range of a specific VLAN Below is an example which you can use for reference. How will I find the IP address range of VLAN 100, VLAN 200 and VLAN 300. 172.29.6.2/25 vlan 100 172.29.7.66/26 vlan 200 172.29.7.135/25 vlan 300

2009年6月22日 · NOTE:After you have created a VLAN in the extended range, you cannot disable this feature unless you first delete the VLAN. To Create a VLAN in the extended range use “set vlan vlan-id [name name]” command.Here the vlan-id would be a number from 1025 to 4096. Numbers 1001 to 1024 are reserved by Cisco and cannot be configured.

2020年8月28日 · Thanks so much. I will like to know if there is a command I can run on Nexus switch to show the ip address range assigned to each vlan on the network? For example Staff_vlan 100 what are the valid ip address for this vlan? I would like a list of vlans and their address ranges. Please help out

2017年6月22日 · In the TenA:VMM-VLAN.Pool VLAN Pool, create one Encap Block. Make this a block of 80 dynamic VLANs; Make sure the VLAN Pools within and between Tenants don't overlap [Note: On many Cisco switches the VLAN range 3698-4049 and VLAN 4094 are reserved, you may wish to avoid these] Step 2: Next create a Physical Domain per Tenant. The Physical ...

2023年7月5日 · 2e. Once all Domains have been bound to the new VLAN Pool, check the "show usage" on the original VLAN pool to ensure its no longer in use. Once its not being used by any other policy, its safe to remove it. **Note: Above applies more to static VLAN pools for non-VMM domains. If your VLAN pool in question involves dynamic VLAN pool range, let ...

2007年5月23日 · verify how u have created the vlan..ie..there are 2 ways of creating the vlans in vlan database mode or from global mode.if u have created the vlans from vlan database mode then go the vlan datase mode and issue the command no vlan vlanid. if it is in gobal mode then go to the global mode and issue no vlan (vlanname) vlanid. Thanks. Mahmood

2014年2月25日 · Searching on the web, found this: DHCP Router Config. conft# interface fa0/0. conft# ip address 200.1.1.2 255.255.255.0