2024年3月4日 · So in Proxmox you can add virtual interfaces for each of these VLANs to pfSense, each connected to vmbr2 and with the respective VLAN ID. Then Proxmox tags packets from the VM, and let only pass the respective VLAN packets to the VM, while removing the tag.

2021年3月15日 · @tlex said in PfSense VM on ProxMox : Qemu-agent installation: Update procedure for PfSense 2.6.0 (Shell) Install Qemu-agent package : pkg install qemu-guest-agent (web gui): Install "Shellcmd" from the package manager "System/PackageManager" (web gui): Create the following "earlyshellcmd" from "Service/Shellcmd": service qemu-guest-agent start

2024年2月20日 · I'm running pfsense in a vm on Proxmox on a Miniforum ms-01. WAN is connected to i266-V intel Nic with DHCP and bridge mode from ISP router on 192.168.0.0/24 IP/subnet. LAN is i226-lm to unmanaged switch / Dumb AP / ethernet to computer on 192.168.1.0/24 IP/subnet. ISP modem is giving DHCP address to Proxmox / Pfsense no problem.

2024年1月11日 · I have a 6x LAN Port server, where I have installed Proxmox and on top of Proxmox I have installed pfSense. Unfortunately, I'm not so familiar with networking and in the beginning of learning. Therefore I ask here, if someone could have a look at my setup, to check, if this setup makes sense and if there are any suggestions what should be changed.

2024年1月20日 · As I can't use the web GUI to log into the device, I connect to my Proxmox host, access the console, and do an option 5 reboot. After it comes back up, it's all fine again. Before I did this in the morning, I pinged a few internal devices and no response, but pinging 1.1.1.1, for example, works just fine.

2024年1月29日 · Proxmox version: 8.1.4; pfSense version: 2.7.2; NIC: i340-t4, i219 (motherboard) Network configuration: vmbr0 is assigned to LAN in pfsense and all other VMs in proxmox, it also has slaved physical port (i340-t4) that connects to rest of the lan; vmbr1 is assigned to WAN in pfsense and it has slaved physical port (i340-t4) to ISP1(DHCP)

2022年9月13日 · @bearhntr pfsense uses most of the ram you give it, I assume for ram buffers. Which means Proxmox can not then use it. Mine does the same. You probably don't want your router to be using swap so just give the pfsense VM what in actually needs & can keep. 4GB is probably plenty.

2023年9月9日 · The pfSense instances are virtualized on Proxmox VE 8. They are running as q35 maskines with OVMF (UEFI ...

2023年8月16日 · IOW, it is not directly connected to pfSense; Proxmox is handling interrupts and data transfer into pfSense's memory. Proxmox is accessible on this bridge as I added an address for it (10.69.0.2). The vmbr2 bridge on enp3s0 is solely for the case in which pfSense is down and therefore cannot be accessed.

2023年12月8日 · @bearhntr said in VIrtualized pfSense (Proxmox) with WiFi - possible?: This script seems to be a Linux (Ubuntu/Debian) I does not mention Proxmox. Correct. Create a VM in Proxmox; Load your prefered Linux from the variants supported by the Unifi controller software; Install the Unifi controller software via the above script