2007年10月4日 · Certainly, I would compare several more to verify - but on this first comparison - it is pretty good. The CCT diagram appears to match pretty well....One thing that you have to pay attention to is the maximum cooling rate - note the differences when I changed the maximum cooling rate from 100K/s to 35 K/s. Edited October 4, 2007 by kb0fhp

2007年12月28日 · Hi guys ! i am starting to use 5160 for forging knives and i am also experimenting in heat-treating blades... (rather cracking them) and i am looking for the CCT / TTT diagram for the 5160. Of course, nothing comes off from search engines on the internet and i am running towards a wall as for inf...

2003年4月12日 · COOL TTT and CCT diagram. By TOM PITTMAN April 12, 2003 in Metallurgy and other enigmas. Share

2013年11月13日 · TTT Diagram for AEB-L. By Cody Killgore November 13, 2013 in Metallurgy and other enigmas. Share

2006年11月19日 · Attached is the CCT Diagram for 5160. It shows that it takes approximately 75 seconds for the material to cool and completely miss the bainite nose or knee (nose or knee depends where you went to school). The MS temperature is approximately 500 F, or 275C. THis is way too high to use an oil - it will burn up!

2005年4月27日 · I can only find one public net reference that speaks about 52100 bainite. Japanese metallurgist types too. They didn't publish the TTT diagram. You're going to need the Heat Treater's Guide or somesuch for those references. However, until I looked, I wouldn't have said that 52100 bainite was likely or possible. All that chrome really affects ...

2024年12月4日 · So I was browsing through the history books of my great aunt, and found an old diagram with a few seaxes in it, one of them apparently being used to slay a beast. Not sure if this is a very well known one, if so mods go ahead and delete this. My Dutch is not very good, but I believe this is suppo...

2005年7月10日 · It would be easyest if you could find a CCT and TTT for the steel you want to try out. If the bainite curve is only what looks like the little tip of what might be a nose down in the right hand corner of the diagram (the ones I have seen did), I don't think you should bother. Would be pretty cool, though.

2003年10月3日 · On the CCT/TTT diagrams, do you or anyone else know where I can get a copy of the diagram for 52100. I know there is an atlas out there with diagrams for many alloys, but I haven't found a copy in my price range. So far I've been able to find a few specific numbers from the bearing makers, but I've never seen the actual diagram.

2014年2月15日 · Here is an exploded diagram to assist with terminology. Many smallsword hilts ,particularly those of the later 18th century, were cast in silver or brass. However, steel smallsword hilts were also common , and I believe most …